Operation; Maintenance - VONROC AG504DC Original Instructions Manual

Mounting the side handle (Fig. A and G)
• The side handle (8) can be screwed into one of
the three side handle connection points (6).

4. OPERATION

Make sure that the work piece is properly
supported or fixed.
Switching on and off (Fig. B)
• To start the machine, press and hold the lockoff
button (2) and press the on/off switch (5).
• To stop the machine, release the on/off switch
(5). Hold the machine away from the work piece
when turning it on and off because the wheel
disc could damage the work piece.
• Clamp the work piece firmly or use another
method to ensure that it cannot move while
working.
• Check the discs regularly. Worn wheel discs
have a negative effect on the machine's effici-
ency. Change to a new wheel disc in good time.
Deburring (Fig. H)
An angle of inclination of 30
give the best results when deburring. Move
the machine back and forth using light
pressure. This will prevent the work piece
from discolouring or becoming too hot and
will avoid making groves.
Never use abrasive cutting discs for
deburring work!
Cutting (Fig. I)
For cutting, a special protection guard must
be used (not included).
Maintain firm contact with the work piece to
prevent vibration and do not tilt or apply pressure
and when cutting. Use moderate pressure when
working, appropriate to the material that is being
worked on. Do not slow down wheel discs by
applying sideways counter pressure. The direction
in which you want to cut is important. The machine
must always work against the direction of the cut;
so never move the machine in the other direction!
There is the risk that the machine will catch in the
cut causing kickback and that you will lose control.
WWW.VONROC.COM
Hints for optimum use
• Clamp the work piece. Use a clamping device
• Hold the machine with both hands.
• Switch on the machine.
• Wait until the machine has reached full speed.
• Place the wheel disc on the work piece.
• Slowly move the machine along the work piece,
• Do not apply too much pressure on the machi-
• Switch off the machine and wait for the ma-

5. MAINTENANCE

Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
to 40 will ventilation openings are free of dust and dirt. Re-
0 0
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
ENVIRONMENT
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
for small work pieces.
firm ly pressing the wheel disc against the work
piece.
ne. Let the machine do the work.
chine to come to a complete standstill before
putting the machine down.
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
EN
13