Operator's Responsibility - Linde HiQ R200 Instructions For Use Manual

4-/ 6-port line regulator
Table of Contents

Advertisement

Available languages

Available languages

WARNING!
Risk of injury from using oil and grease!
Oil and grease must never be used in gas regulating systems. Oil and grease are highly inflammatory and
can react violently to certain pressurized gases.
THEREFORE:
EN
Never use oil and grease
WARNING!
Risk of injury from residual energy stored in the system!
If handled incorrectly, pressurized components can move uncontrollably and cause severe injury. If handled
incorrectly or defective, pressurized components can leak gas under high pressure and cause severe or
even fatal injuries.
BEFORE STARTING WORK WITH THESE COMPONENTS:
Installation only through certified company.
Always wear protective goggles when working.
Always wear ear protection.
Make sure the equipment is depressurized. Also make sure the residual energy is discharged.
Always ensure that gas cannot leak unintentionally.
Make sure that defective components that are pressurized during operation are immediately replaced by
trained staff.
WARNING!
Danger of accident!
Due to wrong installation there can be serious or even mortal injuries.
THEREFORE:
During installation the component should be kept safe
Never throw the component
Pressurised components are only for intended use.
If there are mechanical damages at tubing or components the whole system has to be put in a safe condi-
tion. Affected area has to be blocked. Troubles which could influence safety, have to be eliminated through
qualified staff or supplier.
Especially with gases failure in pressure regulator could happen. Indications for defective regulator is no flow
or immediately rising outlet pressure. In this case system has to be regulating and the relevant department
for maintenance has to be informed. Never close exhaust piping.

2.3. OPERATOR'S RESPONSIBILITY

OPERATOR
The operator is the person who operates the system for commercial or business purposes or who provides
the system for use/application by a third party, and who bears legal product responsibility for protecting the
user, staff or third parties during operation.
OPERATOR'S DUTIES
The system is used for commercial purposes. The operator of the system is therefore subject to legal work
safety obligations.
Compliance with the safety, accident prevention and environmental protection regulations that apply for the
use of the system is mandatory, in addition to the safety information in these instructions.
THE FOLLOWING APPLIES IN PARTICULAR:
The operator must be aware of the applicable work safety regulations and must perform a risk assessment
to identify risks that may occur as a result of the specific working conditions at the site where the system
is operated. The operator must use this assessment as the basis for compiling instructions for operating
the system.
During the entire period in which the system is operated, the operator must ensure that these operating
instructions comply with the latest regulations, and must update the instructions if necessary.
The operator must assign clear and specific responsibility for installation, operation, troubleshooting,
maintenance and cleaning.
8/44

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Hiq r300Hiq r500

Table of Contents