Product Overview; Controls - Toro 29521 Operator's Manual

Product Overview

1. Platform
2. Parking-brake knob
3. Motion-control levers

Controls

Motion-Control Levers
The motion-control levers are located on each side of
the top console and control the forward and reverse
motion of the machine.
Move the levers forward or backward to control the
drive wheel on the same side forward or reverse
respectively. The wheel speed is proportional to the
amount you move the lever.
Important:
The tines rotate when the
motion-control levers are moved out of the
N position.
EUTRAL
Figure 5
4. Engine controls
5. Fuel cap
1. Left motion-control lever
2. Right motion-control lever
3. Front reference bar
4. Front of the machine
Throttle Lever
The throttle lever
console (red lever).
Use the throttle lever to control engine speed. Move
g269241
the throttle lever forward to increase engine speed;
moving the throttle lever rearward to decrease the
engine speed.
Note:
Move the throttle lever forward into the detent
for full throttle.
Choke Lever
The choke lever
console (black lever).
Use the choke lever is used to aid in starting a cold
engine. Move the choke lever forward to set the
choke to the O
N
rearward to reduce the choke.
Note:
Pull the choke lever back into the detent to set
the choke to the O
Note:
Do not run a warm engine with the choke in
the O position.
N
11
Figure 6
5. Forward
6. Neutral
7. Reverse
(Figure 7) is located on the control
(Figure 7) is located on the control
position; move the choke lever to the
position.
FF
g267503