Printronix SL4M Quick Setup Manual page 12

Loading Ribbon And Roll Media
Printhead
Platen
(not shown)
Media Sensor
Assembly
4. Thread the media under the media damper, through the media
NOTE: If you have a standard peel, label or liner rewinder, refer to
NOTE: The alternate media path is for inside wound label media.
CAUTION
If the media width guide locking knob is too loose or is
removed, the media width guide will fall off the printer.
5. Turn the media width guide locking knob counterclockwise just
6. Position the media width guide lightly against the outside edge
12
Media Locking
Width Guide Knob
Media Damper
sensor assembly, and then between the platen and the
printhead.
the User's Manual for proper threading instructions.
enough to slide the media width guide, and no more.
of the installed media and tighten the locking knob by turning it
clockwise.
Alternate
Media
Media Path