Lenovo 10KY Hardware Maintenance Manual page 95

What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 110.
Replacing the 2.5-inch storage drive in the optical drive bay
To replace the 2.5-inch storage drive in the optical drive bay, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 82.
3. Locate the 2.5-inch storage drive in the optical drive bay. See "Computer components" on page 31.
4. Disconnect the signal cable and the power cable from the 2.5-inch storage drive.
5. Remove the screw that secures the 2.5-inch storage drive converter to the storage drive bracket,
and then remove the bracket from the chassis.
Figure 21. Removing the screw that secures the 2.5-inch storage drive converter
6. Remove the four screws that secure the 2.5-inch storage drive to the 2.5-inch storage drive converter.
Then, slide the 2.5-inch storage drive out of the converter.
Figure 22. Removing the 2.5-inch storage drive
7. Take the new 2.5-inch storage drive out of the static-protective package.
8. Slide the 2.5-inch storage drive into the 2.5-inch storage drive converter so that the four holes in the
storage drive align with the corresponding holes in the converter. Then, install the four screws to
secure the 2.5-inch storage drive to the converter.
9. Position the 2.5-inch storage drive converter into the chassis so that the screw hole in the converter
aligns with the corresponding hole in the storage drive bracket. Then, install the screw to secure the
converter to the bracket.
.
Chapter 9 Installing or replacing hardware
89