Lenovo 10KY Hardware Maintenance Manual page 93

12. Reinstall the optical drive or the storage drive in the optical drive bay if you have removed any of them.
See "Replacing the optical drive" on page 82 or "Replacing the storage drive" on page 85.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 110.
Replacing the 2.5-inch storage drive in the primary storage drive bay
To replace the 2.5-inch storage drive in the primary storage drive bay, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the computer cover. See "Removing the computer cover" on page 82.
3. Remove any parts that might prevent your access to the storage drive bracket. Depending on your
computer model, you might need to remove the optical drive or the storage drive in the optical drive bay.
See "Replacing the optical drive" on page 82 or "Replacing the storage drive" on page 85.
4. Locate the 2.5-inch storage drive in the primary storage drive bay. See "Computer components" on
page 31.
5. Disconnect the signal cable and the power cable from the 2.5-inch storage drive.
6. Remove the screw that secures the storage drive bracket, and then remove the bracket from the chassis.
Figure 18. Removing the screw that secures the storage drive bracket
.
Chapter 9 Installing or replacing hardware
87