Ovens; Door Panel; The Tall Oven - Rangemaster 90 Induction User's Manual & Installation Instructions

Table of Contents

Advertisement

DO NOT use harsh abrasive cleaners or sharp metal
n
n
scrapers to clean the oven door glass since they can
scratch the surface, which may result in shattering of
the glass.

Ovens

The oven door front panels can be taken off so that the glass
panels can be cleaned. Move the cooker forward to gain
access to the sides (see the 'Moving the Cooker' section under
'Installation').
'Cook & Clean' Panels
The main oven has side 'Cook & Clean' panels which have
been coated with a special enamel that partly cleans itself.
This does not stop all marks on the lining, but helps to reduce
the amount of manual cleaning needed.
These panels work better above 200 °C. If you do most of your
cooking below this temperature, occasionally remove the
panels and wipe with a lint free cloth and hot soapy water.
The panels should then be dried and replaced and the oven
heated at 200 °C for about one hour. This will make sure that
the panels are working effectively.
Removing the Panels to clean the Enamel
Interior
If you wish to clean the enamel interior of the oven, you will
need to remove the shelves, followed by the 'Cook & Clean'
panels. Each side of the oven is fixed with four fixing screws.
You do not have to remove the screws to remove the oven
panels. Simply lift each side panel upwards, slide them off the
screws and then pull them forwards (Fig.5-8).
Once the panels have been removed, the oven enamel
interior can be cleaned.
DO NOT use steel wool, oven cleaning pads, or any other
materials that will scratch the surface.

The Tall Oven

To clean the oven sides, slide out the shelves, unhook the
supports from the oven sides and lift out (Fig.5-9).
ArtNo.320-0002a Proplus oven door side screws
ArtNo.320-0008 Removing the oven lining
19
ArtNo.320-0022 Tall oven side support
Fig.5-7
Fig.5-8
Fig.5-9

Advertisement

Table of Contents
loading

Table of Contents