Technical Data; Installation - Zanussi ZWF91483WH User Manual

FIXING PLATE KIT
If you install the appliance on a plinth that is not an
accessory supplied by ZANUSSI, secure the
appliance in the fixing plates.

TECHNICAL DATA

Dimension
Electrical connection
Level of protection against ingress of solid particles and moisture
ensured by the protective cover, except where the low voltage
equipment has no protection against moisture
Water supply pressure
1)
2)
Water supply
Maximum Load
Spin Speed
1) The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your do-
mestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the bottom of the water storage tank.
2) Connect the water inlet hose to a water tap with a 3/4'' thread.

INSTALLATION

WARNING! Refer to Safety chapters.
UNPACKING
1. Open the door. Remove all the items from the
drum.
6
Read carefully the instructions supplied with the
accessory.
Width/ Height/ Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
Cotton
Maximum spin speed
2. Put the packaging element on the floor behind
59,7 cm /84,7 cm /65,7 cm
220 - 240 V
2200 W
13 A
50 Hz
IPX4
0.5 bar (0.05 MPa)
8 bar (0.8 MPa)
Cold water
9 kg
1351 rpm
Accessories delivered with the
appliance may vary depending on
the model.
the appliance and carefully put it down onto its
rear side. Remove the polystyrene protection
from the bottom.
CAUTION! Do not lay washing
machine on its front.
1
2