Table of Contents
Advertisement
ENGINE START/STOP Button Functions — With
Driver's Foot OFF The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates similar
to an ignition switch by providing three positions:
OFF, ACC and RUN. To change the ignition mode
without starting the vehicle (to power certain accesso-
ries), follow these steps:
1. Starting with the ignition in the OFF mode.
2. Push the ENGINE START/STOP button once,
without brake pedal being pressed, to place the
ignition in the ACC mode (instrument cluster will
display "ACC").
3. Push the ENGINE START/STOP button a second
time, without brake pedal being pressed, to place
the ignition in the RUN mode (instrument cluster
will display "Ignition or Accessory On").
NOTE:
• The vehicle is not able to be driven in the "Igni-
tion or Accessory On" mode, see "Achieving
Vehicle Is Ready To Drive Mode Using the EN-
GINE START / STOP Button" previously de-
fined in this section for further information.
• The rotary gear selector will turn but only PARK
and NEUTRAL are accessible in the "Ignition or
Accessory On" mode.
4. Push the ENGINE START/STOP button a third
time, without brake pedal being pressed, to return
the ignition to the OFF mode (instrument cluster
will display "OFF").
To Turn Off The Vehicle Using ENGINE
START/STOP Button
1. Place the gear selector in PARK, then push and
release the ENGINE START/STOP button.
2. The ignition switch will return to the OFF position.
3. If the gear selector is not in PARK, the ENGINE
START/STOP button must be held for two sec-
onds, or pushed three short times in a row, with the
vehicle speed above 5 mph (8 km/h) before the
engine will shut off. The ignition switch position will
remain in the ACC position until the gear selector
is in PARK and the button is pushed twice to the
OFF position. If the gear selector is not in PARK
and the ENGINE START/STOP button is pushed
once, the instrument cluster display will display a
"Vehicle Not In Park" message and the engine will
remain running. Never leave a vehicle out of the
PARK position, or it could roll. The vehicle will also
remain in propulsion system active mode.
NOTE:
If the outside ambient temperature is 32°F (0°C) or
below, the instrument cluster will request the vehicle to
be plugged to provide conditioning of the vehicle.
Advertisement
Table of Contents
