Braun 3202 Instructions Manual page 16

SLICING, SHREDDING, GRATING
1. Place the insert you want to use
into the insert carrier and snap into
position (see figure C). In order to
remove the insert, push up the insert
end that protrudes at the bottom of
the insert carrier.
2. Press the assembled slicer/shredder
onto the drive shaft of the food
processor bowl (see figure D).
3. Put the lid onto the bowl and lock
into place. Set the speed and fill the
food to be processed into the filling
tube while the motor is switched off.
Refilling should be done with the
motor switched off.
4. Never reach into the filling tube when the motor is running.
Always use the pusher (see figure E).
E
1
Note: When processing juicy or soft food, you will obtain better results at a
lower speed. Hard food should be processed at a higher speed. Do not
overload the processor bowl. Refer to the chart below to choose the
appropriate attachment for desired food to be processed.
16
C
D