Braun 3202 Instructions Manual page 10

Working With Second Bowl System
1. Only one working bowl can be operated at a time.
2. The working bowl which is not used must be in the upper position or
additionally, can be turned in the «click» direction where it is locked in
place. When the arrow markings are aligned, the bowl can be taken off.
3. For safety reasons, always put the protective cover onto the free drive
shaft after a bowl has been taken off.
Double safety feature
The appliance can only be switched on when the desired working bowl with
lid is properly engaged. If the lid is opened during operation, the motor
switches off automatically. As in this case the motor switch (3) is still on «I»,
turn it back to «O» to avoid switching on the motor accidentally.
ATTACHING THE WORKING BOWLS
The food processor bowl (6) is
operated on the large drive place of
the motor block (1).
1. The chopper bowl is operated on
the small drive place. With the motor
switched off, place the respective bowl
onto its drive place matching the arrow
on the bowl with the arrow on the
motor block (See fig A).
Then turn the bowl in the «function»
direction until the lower fixed stop is
reached. The bowl on the other drive
place must be in the lifted position.
If the other drive place is free, put on
the protective cover (25).
2. Put the attachment needed
(see instructions for each of the
attachments) onto the drive shaft of
the bowl and push it down as far as it
will go (see fig B).
10
NOTE: When using the food
processor bowl, always insert
the required attachments
before adding ingredients.
A
1
2
B
1
2