Table of Contents
Advertisement
VIPA HMI
3
Deployment under Windows CE 6.0 Core
3.1 Installation
Overview
Installation cutting
Installation
Connect power supply
HB160 | TP-ECO | 62P-NHC0 | GB | 16-02
The Touch Panel is suitable for the installation in operating tables and
control cabinet fronts. The installation happens via the backside. The
Touch Panel is provided with a patented fixing technique that allows
an easy connection with a hexagon socket key. A fast and easy
device change is possible.
For the installation into a operating tableau and control cabinet fronts,
the Touch Panel requires the following front plate cutting:
Touch Panel
62P-NHC0-...
For the installation of the panel, 4 mounting clips and a small hex-
agon socket key are required.
1.
Push the operator panel [3] from the front side into the front
panel cutting [1] until it touches the panel with the seal [2].
2.
Put the mounting clips [4] on all four sides of the panel into the
openings. The screws should point in the direction of the front
panel.
3.
Screw the screws from the other side with the hexagon socket
key [5].
For the cabling of the DC 24V power supply a green plug is used. The
connector is a plug with screw contacts. The plug has the following
assignment:
+
DC 24V
-
DC 0V
PE Protective earth
Deployment under Windows CE 6.0 Core
W x H in mm
368 x 290
Installation
25
Advertisement
Table of Contents
