Dc Connectors; Sidestand - Yamaha X MAX CZD300P 2022 Owner's Manual

3. Remove the power outlet cap.
1
1. Power outlet cap
4. Turn the accessory off.
5. Insert the accessory plug into the
power outlet.
1
1. Power outlet
6. Turn the main switch on, and then
start the engine. (See page 8-2.)
7. Turn the accessory on.
Instrument and control functions

DC connectors

This vehicle is equipped with additional
wiring and DC connector(s) for the in-
stallation of optional grip warmers.
Consult a Yamaha dealer for more in-
formation regarding the location and
capacity of the DC connector(s) and
about what accessories are capable of
being installed.
6-34
EAUN4190

Sidestand

The sidestand is located on the left
side of the frame. Raise the sidestand
or lower it with your foot while holding
the vehicle upright.
TIP
The built-in sidestand switch is part of
the ignition circuit cut-off system,
which cuts the ignition in certain situa-
tions. (See the following section for an
explanation of the ignition circuit cut-
off system.)
WARNING
The vehicle must not be ridden with
the sidestand down, or if the side-
stand cannot be properly moved up
(or does not stay up), otherwise the
sidestand could contact the ground
and distract the operator, resulting
in a possible loss of control.
Yamaha's ignition circuit cut-off
system has been designed to assist
the operator in fulfilling the respon-
sibility of raising the sidestand be-
fore starting off. Therefore, check
EAU15306
6
EWA10242