Table of Contents
Advertisement
PROBLEM
Wick fails to ignite
Out of fuel
Electrode does not spark
Water in kerosene (paraffin)/
poor quality kerosene (paraffin)
Smoke or odor
Heat chamber tilted or
improperIy seated
Wick set too high
Dirty wick
Drafts
Contaminated fueI/poor quality
kerosene (paraffin)
Flickering, dying or
Dirty wick
low flame
Water in kerosene (paraffin)/
poor quality kerosene (paraffin)
Wick adjuster knob
Dirty wick
is hard to turn
Poor quality kerosene (paraffin)
Damaged mechanism
Flame too high
Fuel contaminated with
gasoline (petrol) or other highly
flammable material
TROUBLESHOOTING
CAUSE
SOLUTlON
Check fuel gauge; add fuel if necessary.
Check wire connections. Replace batteries.
Drain tank. Install new wick.
Refill with fresh, clean kerosene (paraffin).
Move heat chamber handle until heat
chamber is properly seated and moves
smoothly left and right.
Reduce wick height by turning wick adjuster
knob counterclockwise.
Clean wick as described under "Care and
Maintenance".
Relocate heater.
Drain tank and rinse with clean kerosene
(paraffin). lnstall new wick and refill with
fresh, clean kerosene (paraffin).
Clean wick as described under "Care and
Maintenance".
lf necessary, install new wick.
Drain tank and rinse with clean kerosene
(paraffin). lnstall new wick and refill with
fresh, clean kerosene (paraffin).
Clean wick as described under "Care and
Maintenance".
Drain tank and rinse with clean kerosene
(paraffin). Install new wick and refill with
fresh, clean kerosene (paraffin).
Contact your dealer for service.
lMMEDIATELY shut off heater.
lnspect all components for damage.
Drain tank and rinse with clean kerosene
(paraffin). lnstall new wick and refill tank with
fresh, clean kerosene (paraffin).
14
PAGE
7
6
11
8
9
10
2
10
11
10
11
10
11
10
10
11
3
10
11
Advertisement
Table of Contents
