Information About Your Readings; To Check The Accumulated Readings - Delmhorst Instrument Co P-2000 Owner's Manual

INFORMATION ABOUT YOUR
READINGS
Readings below the nominal range of each scale will be dis-
played as a negative number. Readings above the nominal
range will be displayed with a blinking number. All under-
range and over-range readings should be disregarded. They
are not added to the accumulated readings or used in calcu-
lation of the average or highest reading.
The meter can accumulate up to 100 readings. After all 100
readings are stored, it will not add new readings until the
memory has been cleared. It will also continue to display the
average of all 100 readings as a reminder that the memory
is full.
hTo add a reading to the sum of all the previously stored
readings, release the read key
When taking and storing readings for a specific material, be
sure to clear the meter before moving on to the next scale if
you do not want to group all of the readings together.
TO CHECK THE
ACCUMULATED READINGS
This feature displays the total number of all accumulated read-
ings for the selected material, the average of those readings,
and the highest stored reading.
hTo view the readings, press and release the calibration check
@
key . First the meter displays the number of accumulated
readings for one second, then the average of those readings
for two seconds. Then it displays the highest stored reading
for two seconds. The total "cycle" time is five seconds.
hTo keep the accumulated readings in memory release the cal-
ibration check key
hTo erase readings, hold the calibration check key
more than five seconds. All accumulated readings will be
erased and the meter will display "0".
!
@ before the total cycle time is complete.
within 2 seconds.
@
for
5