Standalone Configuration; Static Mode; Auto Programs; Zoom - Chauvet Professional Ovation F-415FC User Manual

Standalone Configuration

Use standalone configuration to operate the product without a DMX controller.

Static Mode

The Static mode allows for an unchanging color without a DMX controller.
Virtual Color Wheel
1. Go to the Virtual Color Wheel main level.
2. Select Virtual Color Wheel.
3. Select the desired gel color (see
4. Select the desired output level (0–255).
Color Temperature
To select a color temperature, do the following:
1. Go to the Virtual Color Wheel main level.
2. Select Color Temperature.
3. Select the desired color temperature (see
4. Select the desired output level (0–255).
Manual Color Mixer
To do color mixing without a DMX controller, follow the instructions below:
1. Go to the Virtual Color Wheel main level.
2. Select Manual Color Mixer.
3. Select the color to edit (Red, Green, Blue, Amber, or Lime Green).
4. Select the desired output level for that color (0–255).
5. Repeat steps 3 and 4 until product outputs as desired.
Color X-Fade Speed
The Color X-Fade Speed sets the cross-fade speed for Virtual Color Wheel options.
1. Go to the Virtual Color Wheel main level.
2. Select Color X-Fade Speed.
3. Select the desired cross-fade speed (Off, X-Fade Speed 1–4).

Auto Programs

Auto programs allow for dynamic blinder effects without a DMX controller.
1. Go to Auto Show main level.
2. Select the desired auto program (Auto 1–5).
3. Select the desired speed (1–100).

Zoom

This setting allows standalone control of the motorized zoom. To adjust, do the following:
1. Go to Zoom main level.
2. Select the desired output level (0–255).

Master/Slave

The Master/Slave mode allows a group of Ovation F-415FC products (the slaves) to simultaneously
duplicate the output of another Ovation F-415FC (the master) without a DMX controller.
To set each of the slaves:
1. Go to the Master/Slave main level
2. Select Slave.
To set the master:
1. Go to the Master/Slave main level
2. Select Master.
3. Select a static setting.
• The master is the one that runs a program whether in Auto or Static mode.
• Do not connect a DMX controller to the products configured for Master/Slave operation. The
DMX controller may interfere with signals from the master.
• The master should be the first product in the daisy chain.

Dimmer Curve

To set the dimmer curve, follow the instructions below:
1. Go to the Dimmer Curve main level.
2. Select the desired option (Linear, Square, I Squa, or SCurve).
14
Virtual Color Wheel Chart).
Color Temperature
Operation
Chart).
Ovation F-415FC User Manual Rev. 7