Table of Contents
Advertisement
20
180P LCD
Go to cover page
(F)
Fig. 8
3. Main panel and inverter panel removal
Step 1 : Disconnect three connectors (H). See Fig. 10
Step 2 : Remove seven screws (I). See Fig. 10
(H)
Fig. 10
4. Audio and control panel removal
Step 1 : Release five clips (J).
Step 2 : Disconnect two connectors (K), Remove screw (M). See
Fig. 11
Back
Mechnical instructions
Note:
The fluorescent lamps
are consumable. When replace
the lamps, both upper and lower
fluorescent lamps should be
replaced in all cases. If only one
lamp is replaced on either side,
there can be unevenness in the
brightness.
(G)
Fig. 9
(I)
(K)
(J)
5. Inverter PCB removal
Step 1 : Disconnect three connectors (A) and remove screw (B).
See Fig. 12
(A)
6. Disassemble the pedestal
Step 1 : Remove two screws ( C). See Fig. 2
Step 2 : Disconnect one connector (E), remove two screws (D),
release three clips (F). See Fig. 3
Fig. 2
(M)
Fig. 11
(B)
Fig. 12
(C)
Forward
Advertisement
Table of Contents
