Sponge Filter; Troubleshooting - Makita DCL283F Instruction Manual

Sponge filter

When the sponge filter becomes dirty, clean it as
follows.
1. Remove filters that cover the stay.
2.
Pull out the sponge filter from between the pillars.
3.
Clean the sponge filter by tapping or washing. If
you wash it, dry it out thoroughly before use.
4. Insert the sponge filter between the pillars and set
it in the original position. Make sure that each bottom
edge of the pillar holds down the sponge filter, and
there is no gap between the sponge filter and suction
opening.
Fig.35
► 1 . Sponge filter 2. Bottom edge of pillar

Troubleshooting

Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
Noise and vibration
CAUTION:
Do not attempt to repair the cleaner by yourself.
Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw
into.
Attach the wall mount for cordless cleaner to a hard
wooden wall, beam or column, where the wall mount
for cordless cleaner can be firmly secured. Always be
sure that the wall mount for cordless cleaner is securely
attached before hanging the cleaner.
1
Fig.36
► 1 . Wall mount for cordless cleaner
mount violently or hang other appliances than the
cleaner.
2
Area to be investigated
Is the capsule full of dust?
Is the filter clogged?
Is the battery cartridge discharged?
Is the battery cartridge discharged?
Is the filter clogged?
Is the nozzle, pipe or suction inlet of the
appliance is clogged?
Is the nozzle/pipe inlet blocked?
14 ENGLISH
1
CAUTION:
Do not hang the cleaner to the wall
Empty the capsule of dust.
Clean or wash the filter.
Charge the battery cartridge.
Charge the battery cartridge.
Clean or wash the filter.
Remove the clogged objects in the nozzle,
pipe or suction inlet of the appliance.
Do not block the nozzle/pipe inlet.
Fixing method