Sponge Filter; Troubleshooting - Makita DCL181F Instruction Manual

Sponge filter

When the sponge filter becomes dirty, clean it as
follows.
1. Remove the filter.
2.
Pull out the sponge filter from between the pillars.
3.
Clean the sponge filter by tapping or washing. If
you wash it, dry it out thoroughly before use.
4. Insert the sponge filter from between the pillars
and set it in the original position. Make sure that each
bottom edge of the pillar holds down the sponge filter,
and there is no gap between the sponge filter and suc-
tion opening.
Fig.40
► 1 . Sponge filter 2. Bottom edge of pillar

Troubleshooting

Before asking for repairs, check the following points.
Symptom
Weak suction power
Not working
CAUTION:
Do not attempt to repair the cleaner by yourself.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed
by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
Wall mount for cordless cleaner
Optional accessory
NOTE: The screw to mount the holder is not included.
Prepare a screw which fits with the material to screw
into.
Attach the wall mount for cordless cleaner to a hard
wooden wall, beam or column, where the wall mount
for cordless cleaner can be firmly secured. Always be
sure that the wall mount for cordless cleaner is securely
attached before hanging the cleaner.
1
Fig.41
► 1 . Wall mount for cordless cleaner
mount violently or hang other appliances than the
cleaner.
2
Area to be investigated
Is the capsule full of dust?
Is the filter clogged?
Is the battery cartridge discharged?
Is the battery cartridge discharged?
14 ENGLISH
1
CAUTION:
Do not hang the cleaner to the wall
Empty the capsule of dust.
Clean or wash the filter.
Charge the battery cartridge.
Charge the battery cartridge.
Fixing method