Removing A Power-Fan Canister - Bosch DSX-N1D8X4-12AT Installaton Manual

40 en | Maintenance
3.
Refer to
–
8.2.2

Removing a power-fan canister

When you remove a power supply (referred to in SANtricity System Manager as a power-fan
canister), you turn off power, disconnect the power cord, and slide the part out of the shelf.
To remove a power-fan canister:
1.
2.
3.
4.
5.
2021.05 | V3 | DOC
Note: If the second power-fan canister in the shelf does not have Optimal status, do
not attempt to hot-swap the failed power-fan canister. Instead, contact technical
support for assistance.
From the back of the storage array, look at the Attention LEDs to locate the power-fan
canister you need to remove. You must replace the power-fan canister that has its
Attention LED on.
LEDs on the power-fan canister, page 17
Put on antistatic protection.
Unpack the new power supply, and set it on a level surface near the drive shelf.
Save all packing materials for use when returning the failed power supply.
Turn off the power supply and disconnect the power cables:
– Turn off the power switch on the power supply.
– Open the power cord retainer, and then unplug the power cord from the power
supply.
– Unplug the power cord from the power source.
Squeeze the latch on the power supply cam handle, and then open the cam handle to
fully release the power supply from the midplane.
Use the cam handle to slide the power supply out of the system.
As you remove the power supply, a flap swings into place to block the empty bay, helping
to maintain air flow and cooling.
Note: When removing a power supply, always use two hands to support its weight.
Installaton manual
DSA E-Series (E2800 12-bay)
Bosch Security Systems B.V.