Table of Contents
Advertisement
To make sure DiskStation recognizes the new memory capacity:
1 Install DiskStation Manager (DSM). (See the next chapter for more information.)
2 Log in to DSM as admin or a user belonging to the administrators group.
3 Check
Total Physical Memory
in
Control Panel
>
Info
Center.
If your DiskStation does not recognize the memory or does not start up successfully, confirm that the memory is
installed correctly.
To remove the RAM Module:
1 Follow step 1 and 2 of the "To install the RAM module" section to shut down your DiskStation, disconnect the
cables, and then remove the bottom lid.
2 Push the levers on both sides of the memory module outwards. The module will be released from the slot.
3 Hold the memory module by its notches and remove it from the slot.
4 Replace the bottom lid. Replace and tighten the screws removed in step 1.
5 Reconnect the cables removed in step 1. Now, you may turn on your DiskStation.
Attach M2D17 Adapter Card to DiskStation
Your DiskStation supports one M2D17 adapter card. To replace the long bracket with the M2D17 adapter card,
please follow the instructions below.
To install the M2D17 adapter card:
1 Shut down your DiskStation and disconnect all cables from your DiskStation to prevent any possible damages.
2 Open the top cover of DiskStation by removing the 6 screws that secure the main unit.
11 Chapter 2: Hardware Setup
Advertisement
Table of Contents
