Table of Contents
Advertisement
Remote Control Code
This projector has eight different remote control codes (Code 1-Code 8); the factory-set, initial code (Code 1) and the other
seven codes (Code 2 to Code 8). This switching function prevents remote control interference when operating several
projectors or video equipment at the same time. (Change the remote control code for the projector first before changing
that for the remote control unit. See "Remote control" on page 44.)
1
While pressing the MENU button, press the IMAGE button
number of times corresponding to each remote control code
number. Each time you press the IMAGE button, the code is
changed sequentially. (See the list below.)
2
To initialize the remote control code for the remote control
unit, slide the RESET/ON/ALL-OFF switch to the RESET, and
then to the ON. The initial code is Code 1.
Number of Times of
Remote Control Code
Pressing IMAGE Button
Code 1
Code 2
Code 3
Code 4
Code 5
Code 6
Code 7
Code 8
Operating Range
Point the remote control unit toward the projector (Infrared
Remote Receiver) whenever pressing any button. Maximum
operating range for the remote control unit is about 16.4'
(5m) and 60° in front of the projector.
1
2
3
4
5
6
7
8
Part Names and Functions
POINTER
MENU button
While pressing the MENU
button, press the IMAGE
button
number
corresponding to the remote
control code for the projector.
IMAGE button
16.4'
(5 m)
60°
Remote Control Unit
of
times
13
Advertisement
Table of Contents
