Remote Control Code - Canon LV-7490 User Manual

This function allows you to change brightness of
the screen.
.......Brightness according to the input
signal.
..Normal brightness
.....70%-80% of the normal brightness.
.....50% of the normal brightness.
Lamp life control
Select the lamp operation when the total lighting
time of a lamp exceeds the recommended total
hours of use.
The lamp can be turned on even
after exceeding the recommended
total hours of use.
The lamp can be turned on even
after exceeding the recommended
total hours of use. But the projector
turns off automatically after 3
minutes.
the power is turned on. Stored lamp mode will be active after the lamp is stabilized.
replacement icon will be displayed at the time of power-on. Then the projector will turn off after 3 minutes.
The Lamp replacement icon will not appear when the Display function is set to
(p.28).
This projector provides two different remote
control codes: the factory-set initial code (
and the secondary code (
function prevents remote controller interference
when operating several projectors or video
equipment at the same time.
When operating the projector in
the projector and the remote controller must be
switched to .
Select either
Menu.
Press and hold both the MENU and IMAGE
buttons together for 5 seconds or more. After
changing the code, make sure the remote
controller operates properly.
case, switch the code on the remote controller to fit the code on the projector.
reset.
54
). This switching
or in this Setting
)
, both
(p.48), during (p.27), or