Lubrication; Greasing The Bearings; Engine Maintenance; Engine Safety - Toro TimeCutter MX 5025 Operator's Manual

Lubrication

Greasing the Bearings

Service Interval: Every 25 hours—Grease all lubrication
points.
Grease Type: No. 2 lithium grease
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Clean the grease fittings
a rag.
Note: Make sure to scrape any paint off the front of
the fitting(s).
Figure 29
1. Front caster tire
Figure 30
Located on the seat-pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check the tire pressure
every 25 operating hours.
4. Connect a grease gun to each fitting
Figure 30).
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
ARK
(Figure 29 and Figure 30) with
decal106-8717
3. Grease every 25 operating
hours.
4. Engine
(Figure 29 and

Engine Maintenance

Engine Safety

Shut off the engine before checking the oil or adding oil to
the crankcase.

Servicing the Air Cleaner

Service Interval: Before each use or daily
Note: Service the air cleaner more frequently (every few
hours) if operating conditions are extremely dusty or sandy.
Removing the Element
1. Park the machine on a level surface and disengage the
blade-control switch (PTO).
2. Move the motion-control levers to the brake position,
shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean around the air-cleaner cover to prevent dirt from
getting into the engine and causing damage.
4. Lift the cover and remove the hose clamp securing the
air-cleaner assembly to the engine
5. Loosen the hose clamp and remove the paper element
(Figure 31).
g032432
2
3
1. Cover
2. Paper element
29
(Figure 31).
1
G014908
Figure 31
3. Hose clamp
g014908