Stopping The Machine; Adjusting The Height Of Cut; Adjusting The Anti-Scalp Rollers - Toro TimeCutter MX 5025 Operator's Manual

Tow
This is the medium speed. The suggested uses for this speed
are as follows:
•
Bagging
•
Mulching
Mow
This is the fastest speed. The suggested uses for this speed
are as follows:
•
Normal mowing
•
Transporting the machine

Stopping the Machine

To stop the machine, move the motion-control levers to
N and outward to the P
EUTRAL
blade-control switch, ensure that the throttle is in the F
position, and turn the ignition key to O
from the ignition switch.
WARNING
Children or bystanders may be injured if they
move or attempt to operate the mower while it is
unattended.
Always remove the ignition key and move the
motion-control levers outward to the P
when leaving the machine unattended, even if just
for a few minutes.
position, disengage the
ARK
AST
. Remove the key
FF
position
ARK

Adjusting the Height of Cut

Note: The transport position is the highest height-of-cut
position at 115 mm (4-1/2 inches) as shown in
Adjusting the Anti-Scalp
Rollers
Whenever you change the height of cut, adjust the height
of the anti-scalp rollers.
Note: Adjust the anti-scalp rollers so that the rollers do not
touch the ground in normal, flat mowing areas.
1. Disengage the blade-control switch (PTO), move
the motion-control levers to the P
engage the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Adjust the anti-scalp rollers as shown in
match the closest height-of-cut position.
21
Figure
Figure 23
position, and
ARK
Figure 24
23.
g027504
to