Removing The Mower Deck - Toro TimeCutter MX 5025 Operator's Manual

1
1. Adjusting rod
2. Adjusting block
7. After adjustment, check the front-to-rear slope again,
continue adjusting the nut until the front blade tip is
1.6 to 7.9 mm (1/16 to 5/16 inch) lower than the rear
blade tip (Figure 56).
8. When the front-to-rear blade slope is correct, check the
side-to-side level of the mower again, refer to
from Side to Side (page

Removing the Mower Deck

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the P
position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Lower the height-of-cut lever to the lowest position.
4. Remove the hairpin cotter from the front support rod
and remove the rod from the deck bracket
3
2
G014634
Figure 57
3. Locknut
39).
(Figure
3
g014634
1. Front support rod
2. Locking nut
5. Carefully lower the front of the mower deck to the
Leveling
ground.
6. Lift the mower deck and hanger brackets clear of
the rear lift rod and lower the mower carefully to the
ground
ARK
2 2
58).
1
1. Mower deck
2. Hanger bracket
7. Slide the mower deck rearward to remove the mower
belt from the engine pulley.
41
Figure 58
3. Deck bracket
(Figure 59).
3 3
Figure 59
3. Rear lift rod
2
1
G014635
g014635
2 2
G005077
g005077