Honeywell Graceshire 51859 User Manual page 7

FINAL INSTALLATION
4. Remove one of the three fitter plate screws preassembled to the fitter plate and loosen the other two but do not remove. Feed the
single-pin connector through the center hole in the light pan. Align the keyhole slots in the light pan with the loosened screws in
the fitter plate. Turn light pan clockwise and replace the previously removed fitter plate screw. Tighten all screws (Figure 4.4).
5. Remove one of the three light pan screws from the light pan and loosen the other two but do not remove. Connect the single-
pin connector from the light pan to the single-pin connector from the light kit -- blue to black and white to white. Lift the two
keyhole slots in the light kit over the two loosened light pan screws and turn in a clockwise direction. Then, use the previously
removed light pan screw to secure the light kit to the light pan. Tighten all screws (Figure 4.5).
6. Attach the bowl assembly to the light kit by twisting the bowl assembly firmly in a clockwise direction until it is secure.
CAUTION: Avoid cross-threading the bowl assmbly during installation. Improper installation could cause the bowl assembly
to be difficult to remove or fall, which could cause serious injury (Figure 4.6).
7. Remote control comes equipped with a wall bracket. If you wish to install the wall bracket, remove the small plate to expose
the screw holes. Insert wall brackets screws through holes and into wall, then cover with the previously removed small plate.
The remote can be stored in the wall bracket for easy access (Figure 4.7).
Turn on power to fan at breaker box and the wall switch. Assembly is complete.
Single-Pin
Connector
Keyhole
Slot
Fitter Plate Screw
Figure 4.4
Small Plate
Wall Bracket
Screw
Figure 4.7
Fitter Plate
Single-Pin
Connector
Light Pan
Keyhole
Slot
Figure 4.5
Wall Bracket
Light Kit
Light Pan Screw
EN I 7
Bowl Assembly
Figure 4.6
Light Kit