Troubleshooting; Before You Send In The Appliance - Dirt Devil AquaClean M318 Operating Manual

02_M318_gb.book Seite 49 Montag, 21. März 2011 1:15 13

7 Troubleshooting

7.1 Before you send in the appliance

7 Troubleshooting
Before contacting your authorised Royal dealer, Royal service partner or appliance market, first follow
the procedure in the following table to check if you can solve the problem yourself.
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the appliance, put it into the
neutral position, and disconnect it from the mains before starting troubleshooting
"Putting the device into the neutral position".
Problem
Appliance will Water tank has not be mount-
not go into op- ed correctly.
erational readi-
Water tank is empty.
ness mode or
The overheating protection
suddenly stops
device has tripped due to an
producing
empty water tank.
steam.
Cleaning per- The floor was not cleaned be-
formance is not forehand with a vacuum
satisfactory cleaner or brush.
even though the
Stains are stubborn.
appliance is
working fine.
Micro-fibre cleaning cloth is
dirty.
Water filter cartridge is worn
out.
NOTE:
If you cannot solve the problem following the above table, contact our service hotline ( Page 51,
"Warranty") or the Royal customer service ( Page 172, "International Service").
Possible cause
Mount the water tank again,
ing the water tank".
1. Switch off the device, put it into the neutral
2. Fill the water tank,
3. If the overheating protection has tripped, wait
Ensure that the floor has been cleared of loose
dirt before cleaning with the steam mop.
Repeat the cleaning process several times.
If that is not enough, remove the stain before
steam cleaning.
1. Switch off the device, put it into the neutral
2. Wait for about 5 minutes. You can now re-
Replace the water filter cartridge,
"Checking/replacing the water filter cartridge".
Solution
Chapter 3.1, "Fill-
position, and pull the plug from the socket,
Chapter 4.6, "Putting the device into the
neutral position".
Chapter 3.1, "Filling the
water tank".
about 45 minutes before connecting the ap-
pliance again.
position, and pull the plug from the socket,
Chapter 4.6, "Putting the device into the
neutral position".
move the cold micro-fibre cleaning cloth and
replace with a fresh one, Chapter 7.2, "Ac-
cessories and spare parts".
Chapter 4.6,
Chapter 6.1,
49