Table of Contents
Advertisement
10.
Troubleshooting &
FAQs
10�1
Troubleshooting
This page deals with problems that can
be corrected by a user� If the problem
still persists after you have tried these
solutions, contact Philips customer service
representative�
Common Problems
No Picture (Power LED not lit)
•
Make sure the power cord is plugged
into the power outlet and into the
back of the monitor�
•
First, ensure that the power button
on the rear of the monitor is in the
OFF position, then press it to the ON
position�
No Picture (Power LED is White)
•
Make sure the computer is turned on�
•
Make sure the signal cable is properly
connected to your computer�
•
Make sure the monitor cable has no
bent pins on the connect side� If yes,
repair or replace the cable�
•
The Energy Saving feature may be
activated
Screen says
•
Make sure the monitor cable
is properly connected to your
computer� (Also refer to the Quick
Start Guide)�
•
Check to see if the monitor cable has
bent pins�
•
Make sure the computer is turned on�
AUTO button doesn't function
•
The auto function is applicable only
in VGA-Analog mode� If the result is
not satisfactory, you can do manual
adjustments via the OSD menu�
Note
The Auto Function is not applicable in
DVI-Digital mode as it is not necessary�
Visible signs of smoke or sparks
•
Do not perform any troubleshooting
steps
•
Disconnect the monitor from mains
power source immediately for safety
•
Contact with Philips customer service
representative immediately�
Imaging Problems
Image is not centered
•
Adjust the image position using
the "Auto" function in OSD Main
Controls�
•
Adjust the image position using the
Phase/Clock of Setup in OSD Main
Controls� It is valid only in VGA mode�
Image vibrates on the screen
•
Check that the signal cable is properly
securely connected to the graphics
board or PC�
Vertical flicker appears
•
Adjust the image using the "Auto"
function in OSD Main Controls�
•
Eliminate the vertical bars using the
Phase/Clock of Setup in OSD Main
Controls� It is valid only in VGA mode�
Horizontal flicker appears
27
Advertisement
Table of Contents
