Table of Contents
Advertisement
User manual
CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER
Switch off and unplug the washing machine before cleaning the water filter or draining residual water. If you used
a hot wash programme, wait until the water has cooled down before draining any water.
Clean the water filter regularly, to avoid that the water cannot drain after the wash due to obstruction of the filter.
If the water cannot drain, the display indicates that that the water filter may be clogged.
6.
Remove the kick panel: Using a screwdriver, do that which
is shown in the following figure.
7.
Container for the drained water:
Place a low and wide container under the water filter
in order to collect the residual water.
8.
Drain the water:
Slowly turn the filter counter-clockwise until all the
water has come out. Allow the water to flow out without
removing the filter. Once the container is full, close the
water filter by turning it clockwise. Empty the container.
Repeat the procedure until all the water has been
drained.
9.
Remove filter: Lay a cotton cloth beneath the water filter,
which can absorb a small amount of rest water. Then
remove the water filter by turning it out anticlockwise.
10.
Clean the water filter: remove residues in the filter and
clean it under running water.
11.
Insert the water filter and reinstall the plinth: Reinsert
the water filter again by turning it in clockwise
direction. Make sure to turn it in as far as it goes; the
filter handle must be in vertical position. To test water
tightness of the water filter, you can pour about 1 liter
of water into the detergent dispenser. Then reinstall the
plinth.
EN
15
Advertisement
Table of Contents
