Care And Maintenance - Whirlpool AWG 908 E Instructions For Use Manual

CARE AND MAINTENANCE

Appliance exterior and control panel
• Can be washed down with a soft, damp cloth.
• A little neutral detergent (non abrasive) can also
be used
• Dry with a soft cloth.
Appliance internal parts
• After each wash, leave the door open for some
time to allow the inside of the appliance to dry.
• If you never or seldom wash your laundry at
90°C, we recommend to occasionally run a 90°C
programme without laundry, adding a small
amount of detergent, to keep the interior of the
appliance clean.
Do not use flammable fluids for cleaning the appliance.
Detergent drawer
Clean the detergent dispenser regularly, at least three or
four times a year to prevent a build-up of detergent.
1. Press "PUSH" and extract the dispenser drawer.
2. Remove the cover grid from the fabric softener compartment.
Remove the separator from the main wash compartment by
pulling it upwards (see dark arrows).
3. Wash all the parts under running water.
4. Clean detergent from the dispenser with a damp cloth.
5. Refit the separator and the cover grid in the detergent dispenser
and fit the dispenser back inside its housing.
Inlet hose
If a supply hose shows a damage, replace it by a new hose of the
same type, available through our After-Sales Service or your
specialist dealer.
Contact our After-Sales Service team or specialist dealer to obtain a
replacement hose.
Cleaning the mesh filter in the water supply hose(s)
1. Close the tap and loosen the inlet hose on the tap.
2. Clean the internal mesh filter and screw the water inlet hose back
onto the tap.
3. Now unscrew the inlet hose on the rear of the washing machine.
4. Pull off the mesh filter from the washing machine connection
with universal pliers and clean it.
5. Refit the mesh filter and screw the inlet hose on again.
6. Turn on the tap and check that the connections are water-tight.
Door seal
• Clean with a damp cloth when necessary.
• Check the condition of the door seal regularly.
Filter
• Check and clean the filter regularly, at least two
or three times a year (see "Removing the filter /
Draining residual water")
Water supply hose
• Check the hose regularly for brittleness and
cracks.
• Regularly check and clean the mesh filter inside
the inlet hose (see "Cleaning the mesh filter in
the water supply hose(s)").
A
GB 9