Whirlpool AWG 908 E Instructions For Use Manual page 114

FITTING A DÉCOR DOOR TO THE APPLIANCE
The appliance front part has been fitted to accommodate the hinges so that the door can be opened either
from the left or from the right hand side.
Proceed as follows:
1. Screw the hinges onto the décor door, if a dummy drawer front is also being used ensure it to be fastened
to the top edge of the door. Ensure the gap between door and drawer matches the units either side.
2. Fix the two hinge plates to the front of the washer dryer using the two plastic backing pieces.
Note: an 8mm box spanner can be used to screw the thread cutting screws into position.
3. Fasten the two magnetic catches to the opposite side to the hinges and ensure the metal straps are
fastened to the back of the door.
4. Locate the hinges on the door into the two hinge plates on the appliance.
5. If adjustment is necessary this can be achieved by either the hinge plates (vertical) or by the hinge fixing
screws (horizontal).
If a full height door is to be fitted (no dummy drawer front is being used) a top hinge hole has to be drilled
in the door.
The distance between the two hinge hole centres is 360 - 384mm and the distance from the edge of the
door is 21.5mm.
The hinge hole should be max 12mm deep and its diameter 35mm: make sure you do not drill through the
door.
The two fixing holes for the hinge screws are 2mm.
A décor strip can be screwed into position on the edge of the washer dryer. If needed, the strip can be cut
to be adjusted to your furniture but normally this will not be necessary.
FITTING A FULL HEIGHT DOOR
DÉCOR STRIP
TO LINE UP
TO DRILL
GB 14