Download Print this page

Maintenance; Battery Replacement - Extech Instruments UV510-NIST User Manual

Uv light meter

Advertisement

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176 - TestEquipmentDepot.com
3.
Press the R (record) button again to display the minimum value recorded. The
appear on the display.
4.
Press the H (hold) button to clear the recorded data. The previous data will be erased and
the meter will start recording new data.
Long press the R (record) button to exit the record mode.
5.
Auto Power OFF (APO)
In order to conserve battery life, the meter will automatically shut off after approximately 10
minutes of inactivity. The APO icon appears in the display (upper right) when APO is selected.
To set APO ON or OFF as the default condition:
1.
Long press the SET button. The lower display will show 'PoFF'.
Short press the ▲ or ▼ button to enable APO (YES) or disable APO (NO) as shown in the
2.
upper display.
3.
Short press the R (record) button to save the selection.
4.
The meter will return to normal operating mode after approximately 10 seconds.
Note: APO is not operational in record mode.

Maintenance

Battery Replacement

1.
Power OFF the meter.
2.
Remove the flat head screw that secures the battery compartment at the back of the
meter.
3.
Open the battery compartment and replace the 3 'AAA' 1.5V batteries observing correct
polarity. Re-assemble the meter before use
Safety: Please dispose of batteries responsibly; never dispose of batteries in a fire, batteries may
explode or leak. If the meter is not to be used for 60 days or more, remove the battery and store
separately.
Never dispose of used batteries or rechargeable batteries in household waste.
As consumers, users are legally required to take used batteries to appropriate collection
sites, the retail store where the batteries were purchased, or wherever batteries are
sold.
Disposal: Do not dispose of this instrument in household waste. The user is obligated to
take end-of-life devices to a designated collection point for the disposal of electrical and
electronic equipment.
Cleaning and Storage
Periodically wipe the case with a damp cloth and mild detergent; do not use abrasives or
solvents.
5
icon will
UV510-en-GB_V1.0 5/17

Advertisement

loading

This manual is also suitable for:

Uv510