Adjust Anti-Scalp Wheels - Gravely Pro-Turn 400 Series Operator's Manual

7. Remove clutch stop. See Figure 53.
1
1. Clutch Stop
Figure 53
8. Remove transaxle drive belt from drive
system in the following order:
a. From right transaxle sheave.
b. From left transaxle sheave.
c. From engine sheave.
Install Transaxle Drive Belt
See Figure 54.
1. Install transaxle drive belt to drive system
in the following order:
a. Around left transaxle sheave.
b. Around engine sheave.
c. Around right transaxle sheave.
2. Align belt with idler pulley.
3. Reconnect idler arm spring to eye bolt
and secure bolt to unit with nut.
IMPORTANT: Make sure belt has tension and
is aligned in all pulleys.
4
1. Idler Pulley
2. Eye Bolt
3. Right Transaxle
4. Left Transaxle
5. Nut
4. Reinstall clutch stop and mounting
hardware. See Figure 53.
5. Reinstall clutch stop bracket and secure
with original hardware. See Figure 52.
6. Return seat to operating position.
7. Reinstall PTO belt. See Install PTO Belt
on page 35.
8. Reinstall transaxle skid plate and secure
with original hardware. See Figure 50.

ADJUST ANTI-SCALP WHEELS

See Figure 55.
The anti-scalp wheels are set at the factory
for typical mowing height, but can be adjusted
for high or low cutting conditions.
1. Place steering levers in neutral position
and engage parking brake.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Remove hardware securing anti-scalp
wheels to deck and remove wheels.
4. Position wheels as necessary:
• For a very high cutting height, set the
anti-scalp wheels in the lowest position
on the bracket.
EN - 37
2
1
Figure 54
3
5