7. Rotate ROPS to operating position and
secure with lock pins. Secure lock pins
with hairpins. See Figure 7.
2
1. ROPS
2. Lock Pin
3. Hairpin
Figure 7
8. Remove two eccentric spacers, two
round head square neck bolts and two
locking nuts from hardware bag.
9. Rotate steering levers to operating
position and install eccentric spacer
between steering lever plates. Secure
with hardware. See Figure 8.
1. Eccentric Spacer
2. Steering Lever
3. Steering Lever Plate
Figure 8
10. Adjust steering levers. See Adjust
Steering Levers on page 31.
1
3
2
1
3
EN - 13
11. Check tire pressures and inflate to
recommendation. See Check Tire
Pressure on page 26 and see
Specifications on page 45.
12. Make sure deck is level. See Level and
Pitch Mower Deck on page 40.
13. Ensure all hardware is tight.