Gravely Pro-Turn 400 Series Operator's Manual page 34

Figure 39
Adjust Forward Position
The steering lever forward position may be
adjusted for operator comfort.
See Figure 39.
1. Place steering levers in neutral position
and engage parking brake.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Loosen mounting hardware on steering
lever assemblies.
4. Place steering levers in desired position:
• Gently push levers forward for greater
distance from operator.
• Gently pull levers back for closer
distance to operator.
5. Tighten hardware.
IMPORTANT: The steering levers should not
touch each other. There should be no more
than 3.2 mm (1/8") difference between the
horizontal and vertical alignment of the
levers.
Adjust Height
See Figure 40.
The steering lever height may be adjusted for
operator comfort.
1. Place steering levers in neutral position
and engage parking brake.
2. Stop engine, remove key and wait for
moving parts to stop and for hot parts to
cool.
3. Remove steering lever hardware and
remove steering lever from lower control
arm.
4. Position steering lever at desired height
and align with lower control arm. Secure
with original hardware.
5. Adjust steering lever position. See Adjust
Forward Position on page 32.
6. Adjust eccentric spacer so levers are at
the same height and have a 1.3 cm – 2.5
cm (1/2" – 1") gap between lever ends.
See Figure 41.
EN - 32
Figure 40
Figure 41