Advertisement
To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome.
Read this important information carefully before you use the appliance and its accessories and save it for future reference.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable standards and regulations regarding exposure to electromagnetic fields.
General
The hair length settings are indicated in millimeters, the comb cuts the hair to a length of 1 mm to 23 mm. The settings correspond to the remaining hair length after trimming.
Be careful when you trim for the first time. Do not move the trimmer too fast. Make smooth and gentle movements.
Tip: Start trimming at a high length setting and reduce the length setting gradually until you have reached the desired hair length.
Note: You can only use the appliance when it is connected to the wall socket.
Use the trimmer without the trimming comb to trim hair close to the skin (0.5 mm) or to contour the neckline and sideburns
Be careful when you trim without a comb because the cutting unit removes every hair it touches.
Pull the comb off the appliance
Switch on the appliance.
Touch the hair lightly with the trimmer. Make well-controlled movements
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the appliance.
Never immerse the appliance in water and do not rinse it under the tap.
Note: Only the cutting element and the comb can be cleaned with water.
Only replace a worn or damaged cutting unit with an original Philips cutting unit, available from authorized Philips service centers.
To buy accessories or spare parts, visit www.philips.com/parts-and-accessories or go to your Philips dealer. You can also contact the Philips Consumer Care Center in your country (see the international warranty leaflet for contact details).
This chapter summarizes the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, visit www.philips.com/support for a list of frequently asked questions or contact the Consumer Care Center in your country.
Problem | Possible cause | Solution |
The appliance produces an uneven cutting result | The comb does not touch the skin when you move the appliance through the hair. | Make sure the comb is always fully in contact with the skin when you move the appliance through the hair. |
You only move the appliance in one direction. | Because not all hairs grow in the same direction, move the appliance in different directions (upwards, downwards and across). | |
The setting of the comb has changed during trimming. | Check the setting of the comb. If you push the appliance too hard onto the scalp, you may accidentally change the setting of the comb. | |
The comb is not assembled correctly. | Detach the comb and reattach it. | |
The cutting performance decreases when the cutting unit and the comb are dirty. | Clean the cutting unit and the comb (see 'Cleaning'). | |
The appliance does not work when I switch it on | The appliance is not connected to the the wall socket. | Insert the small plug into the appliance and put the supply unit in the wall socket. |
If you need information or support, please visit www.philips.com/support or read the international warranty leaflet.
Warranty restrictions
Cutting units are not covered by the terms of the international warranty because they are subject to wear.
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the HC3505/15 that isn't answered in the manual? Leave your question here.