Table of Contents
Advertisement
HRI6E / LRI6E-11
installation
6) Re-attach the Pressure Regulator wire, and re-situate the Gas Valve, se-
cure the screws that fasten the Gas Valve Mounting Brackets.
7) Remove burner (see burner removal section in manual).
8) Using a 3/8" socket wrench, loosen and remove the main gas orifice.
Replace with the LP gas orifice. Confirm the orifice size marked on the
Orifice with the Rating Label on the appliance
9) Remove pilot retainer clip with pliers and pull off the pilot cap to expose
the pilot orifice.
Pilot retainer clip
28 |
LRI6E / HRI6E-11 Direct Vent Gas Insert
920-053
10) Unscrew the pilot orifice with the allen key; then replace with the LPG pilot
orifice and the pilot cap, provided in the kit.
11)
Ensure the pilot light is in the correct orientation to the Burner. Recon-
nect the gas and electrical supply to the appliance. Start the appliance.
(see section on Lighting Instructions) Ensure that pilot and burner igni-
tion is completed without delay. Check both your inlet and outlet pres-
sures at full load. With a soapy solution, leak test the entire system.
Verify both the correct flame and pilot appearance.
12) See Gas Pipe Pressure Testing in manual.
13) Adjust aerations settings - see Air Shutter Adjustment section in the
manual.
These instructions must be left
2
Installer Notice:
with the appliance
.
02.05.19
Advertisement
Table of Contents
