Linear Vibration Welder 6000 Series
Calibration XDUC (Position Transducer)
Touch the Calibration XDUC (Position Transducer)
button at the top of the Utilities screen, to activate the
calibration screen shown in Figure 6-36 below.
Page 80
User's Manual
Figure 6-36 Utilities > Calibration - Position Transducer Pop-up Window
(Continued on next page.)
NOTE
The position transducer was calibrated at
the factory and normally will not need to be
calibrated again. However, calibration would
be needed for any replacement transducer.
Dukane Manual Part No. 403-619-00