Dukane 6000 Series User Manual page 34

Linear Vibration Welder 6000 Series
E-STOP Reset
E
-
Pressing the button enables the operator to reset the welder
when it is initially turned on or to clear an aborted cycle
caused by:
1. Pushing the
EMERGENCY STOP
2. Opening the rear service doors.
3. Required reset on initial power up.
E-STOP
F
- (button)
E-STOP
The button on the control panel is shown in
Figure 4-1. The switch box (Figure 4-3) contains an
emergency stop (E-STOP) switch and an OPERATE button
as shown in Figure 4-2 and Figure 4-3. The switch on
the control panel and switch box function the same, and
pressing either switch stops the weld cycle and freezes the
lift table in its current position.
Both emergency stop buttons must be in their reset
position before the welder can be restarted and the table
to be lowered.
Page 28
User's Manual
(button)
(E-STOP) button.
NOTE
Follow the instructions shown in the
message area at the top of the touch
screen.
Dukane Manual Part No. 403-619-00