Control Panel - Kruger KGVG3200 PLUS Instruction Manual

CONTROL PANEL

9
9
3
10
2

1 General switch

2 Display

3 Water-filling cap

4 Steam adjustment knob

5 Connector block for hose

6 Detergent switch

7 Steam release lever

8 Hot water function button

9 Detergent tank cap

10 Detergent tank
PREPARATION and START TO USE
Open the cap (3) and fill the tank with tap water.
-Note: If the water available should be
"very hard"(>20°F), It is recommended the use of 50%
demineralized water or distilled water, (this to avoid
excessive limestone formations and to be sufficiently
conductive)
ATTENTION: Do not add detergents, anti-limestone
solutions or essential oils in the water tank boiler, these
can cause irreparable damage to the boiler and circuits.
The manufacturer is not responsible for any damage
caused by improper use.
Connect the plug to a socket on an electrical
interconnection conformed to the rules of the country,
equipped with a switch and an efficient earth terminal.
START TO USE:
Turn on the main switch (1). The pump will charge the
boiler before starting heating. The display (2) will turn
on and will indicate "On" for a couple of seconds, the
revision index of the pcb, the liters of water consumed
and will proceed with the "Hot" heating status of the
machine. When it is ready it will show "GO".
Normally the machine at maximum power takes about 2
÷ 3 minutes to reach the ready state. When the
machine is ready, choose the accessory suitable for the
type of use required and connect it to the multi-function
handle, using the extension tubes, then insert the hose
connector as indicated in the image.
6
5
4
1
When the machine is ready, to release steam through
the handle of the flexible, press the lever button (7).
Now use the brush or accessory in the surfaces to be
cleaned.
Attention: it is recommended to perform the first
release of steam after the heating on a container for
about a minute, this is to collect any condensate water
generated in the initially cold ducts.
Attention: if you are working on delicate
surfaces or things, keep the steam jet at an
adequate distance of at least 20-40cm.
STEAM RELEASE REGULATION:
Through the regulation knob (4) placed
frontally on the machine, you can gradually adjust the
release of the steam.
END OF WATER: The acoustic and the visual
indicator of the display (2), indicates when there is no
more water inside the tank by showing "H2O", this is
why the machine will stop the steam release.
WATER SUPPLY:
Proceed as described:
Open the cap (3) and refill the tank with water (see
note PREPARATION).
Close the cap.
Push the lever button (7) of the hose handle to re-start
working. (you can hear the pump starting to work)
please wait a few seconds and then re-start your
cleaning operation with steam.
HOT WATER FUNCTION
To activate/deactivate the function press the button
(8) on the handle of the hose (see picture below).
Warning: with the function active, the display shows
"H2O" and hot water and steam will be dispensed
using the dispensing lever (7).
12