Kobalt KCW 5024B-03 Manual page 9

OPERATING INSTRUCTIONS
3. Direction-of-Rotation Selector
(Forward/Center Lock/Reverse)
The direction of bit rotation is reversible and is
controlled by a selector located above the variable-
speed trigger switch (D). With the impact wrench
held in the normal operating position, pointing
away from you:
a. Position the direction-of-rotation selector (C) to
the left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the
right of the tool for reverse rotation.
c. Setting the selector in the center (locked)
position helps reduce the possibility of
accidental start-up when not in use.
NOTICE: To prevent gear damage, always allow the impact wrench to come to a complete stop
before changing the direction of rotation.
NOTICE: The impact wrench will not run unless the direction-of-rotation selector is engaged fully
to the left or right.
4. LED Worklight
The LED worklight (B), located above the variable-
speed trigger switch (D) of the impact wrench, will
illuminate when the variable-speed trigger switch
is depressed. This provides additional light on the
surface of the workpiece for operation in lower-
light areas. The LED worklight will automatically
turn off approximately 10 seconds after the
variable-speed trigger switch is released.
a. The LED worklight will blink rapidly if the
tool has stopped working in order to protect
internal circuits; please wait for the tool to cool
down, at which point it can be started again.
b. The LED worklight will blink slowly to indicate
that the battery charge is very low.
3
FORWARD
C
4
B
9
REVERSE
C