Plantronics T10 User Manual page 13

T10 Final w_warranty 4/20/00
STEP 1
IMPORTANT SAFETY INSTRUCTIONS
14. Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:
a) When the power supply cord or plug is damaged or frayed.
b) If liquid has been spilled into the product.
c) If the product has been exposed to rain or water.
d) If the product does not operate normally by following the
operating instructions. Adjust only those controls that are
covered by the operating instructions because improper
adjustments of other controls may result in damage and
will often require extensive work by a qualified technician
to restore the product to normal operation.
e) If the product has been dropped or the base unit has
been damaged.
f) If the product exhibits a distinct change in performance.
15. Never install telephone wiring during a lightning storm.
16. Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
17. Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at the network
interface.
18. Use caution when installing or modifying telephone lines.
19. Keep all product cords and cables away from operating
machinery.
4:09 PM Page 14
4
STEP 1
SETUP
Connect the Telephone Line Jack
16
using the Line Cord.
Allow the unit to initialize for 45
17
seconds before use.
Turn the T10 base over and insert the Headset Holder.
Set the Tone/Pulse Switch to match your phone service (usually
5
tone). If you are not sure, call your local telephone provider.
Set the Ringer Volume Control for incoming calls to your
6
preferred level.
Plug the Headset Cord into the Headset Jack.
18
For most U.S. users, the Flash Timing Switch
"3", however, trying other settings will not harm the T10 or your
phone line.
SAVE THESE INSTRUCTIONS
to the telephone wall outlet
G
1
10
should be set to
4
5