Factory Settings; Application Programming Interface (Api) - Genelec 4410A Operating Manual

The acoustic measuring tool normally used by AV installers can be used to set
these adjustments. Careful listening with test recordings is also recommended.
For each parametric filter, select the filter by clicking on the filter box icon. Select
the function for this filter in the Type drop down box. Each parametric filter has
up to three slider controls that set the parameter values. Quick selections are
also provided for Bass Roll-off, Bass Tilt and Treble Tilt.
Figure 7. Modifying the acoustic settings of a Smart IP loudspeaker.

Factory settings

The factory setting for all acoustic settings is "OFF", sensitivity attenuator set to 0
dB, and delay set to 0 ms. These give a flat anechoic response. Audio stream
settings are reset. With the factory settings, all that is needed to play audio is to
configure an audio-over-IP stream in the stream input. Set stream again to
resume normal streaming operation.
To reset a 4410A to factory settings, press the power button for more than 10
seconds. The loudspeaker indicates that the reset process starts. Then, you can
release the power button but do not disconnect power supplied by the Ethernet
cable until the reset process is complete. Once the reset is complete, the
loudspeaker again becomes available and active on the Smart IP Manager
software. This typically takes less than one minute.

APPLICATION PROGRAMMING INTERFACE (API)

The 4410A Smart IP loudspeaker has a set of API commands that can be used
to enable control using a house automation system or similar IP network
connected device. The document describing the API command and how to use
them is available from Genelec. Please visit www.genelec.com.
10
Set 'delay' and
'sensitivity' as
needed.
Click on a filter
button, select 'filter
type' and adjust
parameters.
Select 'preset' to
assign all parameters
for selected speaker.