Plantronics Voyager 510S User Manual

Bluetooth headset system

Hide thumbs Also See for Voyager 510S:

Setup manual (21 pages)

Quick start manual (11 pages)

Specifications (2 pages)

Table Of Contents

Table of Contents

Quick Links

Need help?

Do you have a question about the Voyager 510S and is the answer not in the manual?

Questions and answers

Summary of Contents for Plantronics Voyager 510S

Page 1 Tel: (800) 544-4660 www.plantronics.com © 2005 Plantronics, Inc. All rights reserved. Plantronics, the logo design, Plantronics and the logo design combined, and Voyager are trademarks or registered trademarks of Plantronics, Inc. The Bluetooth name and the Bluetooth trademarks are owned by Bluetooth SIG, Inc., and are used by Plantronics, Inc. under license. Patents U.S.
Page 2 VOYAGER 510S ™ BLUETOOTH ® HEADSET SYSTEM User Guide...
Page 3 VOYAGER Speak volume major adjust switch Handset lifter (optional) Call control button & talk/on line indicator light Power indicator light (red) Charging cradle Speak volume fine adjust buttons Listen volume major adjust switch 510S SYSTEM DIAGRAMS ™ Telephone receiver jack AC adapter jack Handset lifter jack...
Page 4 Eartip AC adapter CONNECTING YOUR VOYAGER 510S BASE 1. Connect telephone receiver cord to receiver jack in the Voyager 510S Bluetooth System base (referred to as “base“ from this point on). Note: The access to the receiver jack is fairly small.
Page 5: Basic Information
Bluetooth Headset System. ® Note: The headset can also be used with other Bluetooth audio devices. See page 6 for cell phone pairing instructions. For safety and regulatory information, please refer to the separate “Important Safety and Regulatory Information” booklet. A copy of the Declaration of Conformity can be found at www.plantronics.com/documentation.
Page 6: Fitting The Headset
POWERING THE HEADSET ON AND OFF To turn the headset on, press and hold the power/mute button for 3 seconds until the status indicator flashes blue. To turn off, press and hold the button again for 3 seconds until the status indicator flashes red.
Page 7 1. Turn on mobile phone. Place headset in pairing mode by PLT 510 2. Use your phone’s menu to search for Bluetooth audio devices 3. When the phone display asks for a passkey, enter: 0000. PAIRING PAIRING HEADSET AND BASE The Voyager ™...
Page 8: Placing & Answering A Call
(A) or base (B) to answer the call. To disconnect, press call control button on headset or base. Mobile phone: Press the call control button on the headset (A) to answer the call. To disconnect, press call control button on headset.
Page 9: Volume & Mute
(B) as shown until a satisfactory sound level is experienced. Note: This setting only adjusts the headset listen level on calls placed using the desk telephone and cannot adjust the headset listen volume when used with a mobile phone.
Page 10: Handset Lifter (Optional)
HANDSET LIFTER (OPTIONAL) OPERATION WITH THE HANDSET LIFTER ACCESSORY The Plantronics Handset Lifter is an accessory that has two functions: • To automatically notify you when an incoming call is detected even when you are away from your desk. • To lift or replace the telephone handset from its cradle even when you are away from your desk.
Page 11: Making And Receiving Calls
HANDSET LIFTER (OPTIONAL) SWITCHING FROM HANDSET TO HEADSET WHEN USING LIFTER If you are using the telephone handset during a call and want to switch to your headset, press the call control button on either the headset or base unit.
Page 12: Maintenance Hints
If you remain out of range for more than 10 minutes the system will drop the call permanently. If using a Plantronics Handset Lifter, the handset will be replaced and the call terminated. LOW BATTERY WARNING When the headset battery is running low, an audible warning will be heard through the headset as a single beep repeating every 20 seconds.
Page 13: Troubleshooting
Check that the AC adapter is connected to the base unit. Check that the AC adapter is connected to the wall outlet. Check that the AC adapter is the model supplied by Plantronics. SOLUTION Turn it on by pressing and holding the power/ mute button for approximately 3 seconds, until the status indicator light flashes blue.
Page 14 Check that the telephone receiver is connected to the base unit’s telephone receiver jack. Call your supplier or local Plantronics office for help. SOLUTION switch setting as described on page 8. If your telephone has a receive volume control, lower this until the distortion disappears.
Page 15: Regulatory Notice
If you are unsure of restrictions, you are encouraged to ask for authorization before turning on the wireless radio. NOTE: Modifications not expressly approved by Plantronics, Inc. could void the user’s authority to operate the equipment. FCC REGISTRATION INFORMATION If this telephone equipment causes harm to the...
Page 16: Product Registration
(1) this device may not cause interference, and (2) PRODUCT REGISTRATION PLANTRONICS TECHNICAL ASSISTANCE CENTER For assistance and accessibility information, call the Plantronics Technical Assistance Center (TAC) 800-544-4660 x5538, or visit our website at www.plantronics.com. INDUSTRY CANADA NOTICE this device must accept any interference, including interference that may cause undesired operation of the device.

This manual is also suitable for:

510sl

Plantronics Voyager 510S User Manual

Quick Links

Need help?

Questions and answers

Related Manuals for Plantronics Voyager 510S

Summary of Contents for Plantronics Voyager 510S

This manual is also suitable for:

Table of Contents