Table of Contents
Advertisement
Date: 2021-01-13
Version: 1.5
5
Installation
5.1
Notes
► All work described here may only be carried out on a pressure- and voltage-free system.
The system must be protected against restarting.
► All work described here may only be carried out at a standstill.
The system must be secured against restarting.
► The safety and accident prevention regulations given in these documentations must also
be observed.
► Assembly work must be carried out by the manufacturer, by specially briefed personnel or
by trained personnel.
If you have any questions, contact our customer service.
ABB Automation GmbH
Grüner Weg 6 | 61169 Friedberg | Germany
Tel.: +49 6031 85307
E-mail:
For further information, see our website
5.2
Tools and accessories
The following tools and accessories are required for installation, uninstallation, maintenance
and repair of the assembly:
► Set of Allen keys
► Set of open-end spanners
► Screwdriver Set
► Electrical clamping tools
► Oil filter spanner
5.3
Uninstalling the assembly
Uninstalling the entire assembly is not supported. Only individual components, such as process
and oil filters and the release agent itself are replaced as part of regular maintenance (see
Chapter 6).
© 2021 ABB Automation GmbH |
Operating and installation instructions
Central lubrication unit
Installation
NOTE
Page 17 of 25
en
Advertisement
Table of Contents
