Chapter3. Installa�On Of Accessories; Installing/ Removing The Antenna; Installing The Belt Clip - Radioddity GT-82 User Manual

Chapter3. Installation of Accessories

Before the radio is ready for use we need to a�ach the antenna and ba�ery pack, as well as charge the ba�ery.

a. Installing the Antenna: Screw the antenna into the connector on the top of the transceiver by holding the antenna at its

base and turning it clockwise un�l secure.

b. Removing the Antenna: Turn the antenna counter-clockwise to remove it.

a. At the back of the radio there are two parallel screws mounted above the ba�ery, remove these and thread them through

the holes on the belt clip as you screw them back into the radio body.

b. Removing the Belt Clip: Unscrew counter-clockwise to remove the belt clip.

3.3 Installing the ba�ery pack

Before a�aching or removing the ba�ery make sure your radio is turned oﬀ by turning the power/volume knob all the way

counter-clockwise.

a. Make sure the ba�ery is aligned in parallel with the radio body with the lower edge of the ba�ery about 1-2cm below

Table of Contents

Chapters