Sewing - Brother BAS-311H Basic Operation Manual

7. SEWING

7. SEWING
Do not allow any liquids to get onto this sewing machine, otherwise fire, electric shocks or operating problems may
occur.
If any liquid gets inside the sewing machine (machine head or control box), immediately turn off the power and
disconnect the power plug from the electrical outlet, and then contact the place of purchase or a qualified
technician.
Turn off the power switch at the following times.
If the foot switch is depressed by mistake, the sewing machine might start operating and injury could result.
• When threading the needle
• When replacing the bobbin and needle
• When not using the machine and when leaving the machine unattended
Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in
personal injury or damage to the machine.
7-1. Sewing
1st step
2nd step
40
WARNING
CAUTION
1. Turn on the power switch.
3109B
2. Press the
number that you would like to use.
* Refer to "6-3. Reading additional sewing data" for
details on reading sewing data from a SD card.
3. Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, lower the work clamp
(3) before depressing the start switch (2).)
• The feed mechanism will move to the home position.
4441Q
4. Place the material under the work clamp (3).
5. Depress the foot switch to the 1st step.
4979Q
(If using a two-pedal foot switch, depress the work
clamp switch (4).)
• The work clamp will be lowered.
6. Depress the foot switch to the 2nd step.
(If using a two-pedal foot switch, depress the start switch
(2).)
• The sewing machine will start sewing.
7. After sewing is completed, the thread trimmer will
operate, and then the work clamp (3) will be raised.
Use a work clamp which will hold the material securely
so that it does not slip. If the material slips when using
the standard work clamp and feed plate, process them
so that the material does not slip.
3110B
BAS-311H
or key (1) to select the sewing program