Miele G 7856 Operating Instructions Manual page 36

Programming special functions
5. Altering the temperature and/or the
temperature holding time in the
"Main wash" and "Final rinse"
programme stages
Please make a note of any changes
to the temperature and / or the
temperature holding time in the
appropriate section of the
programme chart.
The programme chart shows the factory
settings for the Main wash temperature
together with temperature holding time
and the Final rinse temperature with its
temperature holding time.
The special functions can be used to
alter the temperatures of the main wash
and of the final rinse from 30 °C -70 °C
and the temperature holding time from
1-10 minutes.
Important: We recommend
programming a main wash temperature
of 60°C for cleaning dirty crockery.
The final rinse temperature cannot be
programmed or altered in the , BEER
GLASSES programme.
^ Turn the programme selector to the
STOP position f (the programming
level is displayed only in this switch
position).
^ Switch the machine off.
^ Press and hold 4 and 6 at the
same time, and whilst doing so
switch the machine on with the I-0
button.
The current programme status "P..."
appears in the display and the p / 6
indicator lights up.
36
^ "Main wash" temperature:
Press 3 three times, E03 for
programming level 3 will appear in
the display.
^ Turn the programme selector to the
programme which needs to be
changed. The actual value appears
in the display after °C.
^ Press 4 or hold it in, until the
required value appears in the display.
^ "Main wash" temperature holding
time:
Turn the programme selector to the
STOP position f
(the programming level is only
displayed in this switch position).
^ Press 3 again, E04 for
programming level 4 will appear in
the display. Then:
^ Turn the programme selector back to
the programme which needs to be
changed. The actual value appears
in the display after min.
^ Press 4 until the required value
appears in the display.
^ "Final rinse temperature:
Turn the programme selector to the
STOP position f
(the programming level is only
displayed in this switch position).
^ Press 3 again, E05 for
programming level 5 will appear in
the display. Then: