Table of Contents
Advertisement
Device setup
NOTE: Linking mode lasts for 12 seconds; if no signal is received from a
remote handset during this time then the dimmer will automatically exit
learning mode without linking the device.
If, when expecting a blue LED flash to confirm pairing, a slow amber LED
flash is received instead, the dimmer switch memory is FULL and no further
remotes may be linked with it unless one of the existing remotes is first
unpaired (see below).
Unlinking controllers
Removing a single device:
1. On the dimmer switch, press and hold down
both the 'o ' and 'on' buttons until the blue and
amber LEDs flash alternately then release them.
The dimmer switch is now in linking mode.
2.
Using the LightwaveRF Smartphone App,
enter the edit menu and press the delete button
next to the relevant device (the App instructions
will guide you through this). If using another
controller press the button that you intend to
unlink. The amber light on the dimmer switch will
flash to confirm that the App is now unlinked.
Advertisement
Table of Contents
